Panasonic LX-TD500 Programming Manual page 201

6. Point to
• "Copying" is displayed while the source data is being copied to the destination.
• Parameters of the destination Trunk Lines are immediately effective when copying is
finished.
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Programming Guide
and click.
Card No.
—
XXX: YYY [XXX: Card No. (101-314), YYY: Card Type]
Specifies the physical number of the trunk card and its type, which
you are going to program.
• 1.2 Slot Assignment (P/G)
Port No.
1
1 - n [n = 4 (DID), n =16 (BRI), n = 23 (PRI23), n = 24 (T1), n = 8
(Others)]
Specifies the trunk port which you are going to program.
• 1.3 Trunk Port Assignment (P/G)
Copy
—
—
You can enter into "Trunk Line Copy" screen by clicking this
button.
—
Group No.
(Display only)
1-48
Displays the Trunk Group to which the trunk line is assigned.
Note
• Each trunk line is assigned to a Trunk Group in Section
"1.3 Trunk Port Assignment."
• 1.3 Trunk Port Assignment (P/G)
Line
201