Panasonic LX-TD500 Programming Manual page 342

Programming Error Messages
Error Code
E1037 Cannot change the status of the port.
Cannot change the status of the SLT port because the PT port is activated as a "Parallel
Mode" extension. Please change the PT port status to "XDP Mode" and then press
"Apply."
E1038 You have exceeded the shelf limit of extension ports.
There is a limit of 192 extension ports per shelf when using PLC, HLC, SLC, SLC-M,
OPX, DLC, DHLC or ESLC cards. Please de-assign one card and try again.
E1039 You have exceeded the shelf limit of SLT ports.
There is a limit of 160 SLT ports per shelf when using HLC, SLC, SLC-M, DHLC or
ESLC cards. Please de-assign one card and try again.
E1050 The slot next to PRI23 card must be empty.
Please remove and re-assign the card that is installed next to a PRI23 card. A PRI23
card must go into slot no. 1, 3, 5, 7, 9, 11 or 13.
E1053 PRI card must be assigned to an odd numbered slot.
PRI card should be assigned to the odd numbered slot of basic shelf, expansion shelf
1 and expansion shelf 2.
E1054 The status of the card must be "OUS (Out-of-Service)."
When you change the card properties of PRI23 or BRI card, the status must be OUS
(Out-of-Service)."
E1056 Value of Max. must be larger than value of Min.
Detection time value of "[Tone-ON Time/Tone-OFF Time] Max." must be larger than
that of "[Tone-ON Time/Tone-OFF Time] Min."
E1058 Assign ISDN Ext. under "1-8 BRI Port Assignment."
When you open "4-6 ISDN Extension Line" screen, an ISDN extension must be
assigned on "1-8 BRI Port Assignment" screen.
E1059 VPS card duplicated.
Each physical number of the VPS Card (Jack 1-8) and VPS Card (Jack 9-12) must be
assigned uniquely.
E1060 You have exceeded the limit of VPS(DPT) port per DLC card.
There is a limit of 8 VPS(DPT) ports per DLC card.
E1061 You have exceeded the shelf limit of VPS(DPT) port.
There is a limit of 16 VPS(DPT) ports per shelf.
E2001 Invalid time format.
Please specify the time as Hour:[0]1-12, Minute:[0]0-59.
E2002 Assign the time of beginning and ending in a pair
Cannot assign just the start time or just the end time of Lunch/Break service. Both must
be assigned as a pair.
342
Error Message
Description
Programming Guide