Configuring A Two-Degree Node For Express Traffic - Juniper PTX3000 IPLC Features Manual
Packet transport router integrated photonic line system
Hide thumbs
Also See for PTX3000 IPLC:
- Quick start manual (48 pages) ,
- Hardware manual (174 pages) ,
- Quick start manual (37 pages)
Table of Contents
Advertisement
Configuring a Two-Degree Node for Express Traffic
Copyright © 2018, Juniper Networks, Inc.
For metro linear and metro ring topologies that require a two-degree node, you can
connect two IPLC base modules together to form a two-degree IPLC node. This enables
you to run express traffic in two directions. This topic describes how to setup and configure
an IPLC two-degree node.
Before you begin, complete the following hardware tasks:
Install and connect the two IPLC base modules together through the
ports. These two IPLC modules form the two-degree IPLC node.
BEST PRACTICE:
the same FPC/PIC slot pair on the PTX3000 chassis.
Connect the
and
Line IN
each direction.
BEST PRACTICE:
from the
Line IN
disable the optical supervisory channel and the erbium-doped fiber amplifiers
on the IPLC.
Always refer to the PTX3000 Packet Transport Router Hardware Guide when
connecting or disconnecting cables on the IPLC modules. See
Transport Router Hardware Guide
To configure a two-degree IPLC node:
On the first IPLC base module, specify that the traffic on the
1.
is express traffic.
[edit]
user@host# set chassis fpc slot
For example, if the first IPLC base module resides in slot 1 and the second IPLC base
module resides in slot 2, enter the following:
[edit]
user@host# set chassis fpc 1 optical-options
On the second IPLC base module, specify that the traffic on the
2.
ports is express traffic.
[edit]
user@host# set chassis fpc slot
For example, if the second IPLC base module resides in slot 2 and the first IPLC base
module resides in slot 1:
Chapter 3: Configuring Integrated Photonic Line Card Nodes
We recommend that you place the IPLC modules into
ports on the two IPLC modules to the fiber span in
Line OUT
Anytime you need to disconnect or connect the fiber span
and
ports on the IPLC module, we recommend you
Line OUT
.
optical-options express-in
express-in
optical-options express-in
PT IN
and
PT OUT
PTX3000 Packet
PT IN
and
PT OUT
ports
fpc slot
fpc 2
PT IN
and
PT OUT
fpc slot
21
Advertisement
Table of Contents
Troubleshooting
