Resetting An Optical Inline Amplifier Through The Junos Os Cli - Juniper PTX3000 IPLC Features Manual

Related
Documentation

Resetting an Optical Inline Amplifier Through the Junos OS CLI

Copyright © 2018, Juniper Networks, Inc.
user@host# show
no-disable-osc;
}
Save your configuration.
5.
[edit chassis fpc 2 optical-options]
user@host# commit
Enabling or Disabling the Optical Supervisory Channel Laser on page 82
optical-options on page 100
If you need to reset an optical in the amplifier chain, you can do so from the Junos OS
CLI. This topic describes how to perform either a soft or hard reset on the optical ILA.
Before you begin this procedure, make sure:
The PTX3000 integrated photonic system is up and operational
You have previously configured the optical supervisory channel (OSC) and that it is up
and running
There are two ways to reset the optical ILA:
Soft reset—Does not impact traffic traversing the unit.
Hard reset—Impacts traffic traversing the unit.
To reset an optical ILA from the Junos OS CLI:
(Optional ) To perform a soft reset, access the amplifier chain configuration hierarchy
1.
and specify the unique identification number of the optical ILA.
user@router# run request chassis fpc optical-module amplifier-chain ila soft-reset
fpc-slot 5 ila-number 2
(Optional ) To perform a hard reset, access the amplifier chain configuration hierarchy
2.
and specify the unique identification number of the optical ILA.
user@router# run request chassis fpc optical-module amplifier-chain ila hard-reset
fpc-slot 5 ila-number 2
Whether you perform a soft or hard reset, verify that the Junos OS CLI responds with
3.
the following message.
Reset command was successfully issued to the requested ILA
Verify that the reset is complete and the software is now running.
4.
Chapter 10: Troubleshooting and Maintenance
83