Juniper PTX3000 IPLC Features Manual page 85

Chapter 8: Example: Configuring the PTX3000 Integrated Photonic Line System in a Metro Linear Packet Optical Network
Step-by-Step
Procedure
Step-by-Step
Procedure
Results
Copyright © 2018, Juniper Networks, Inc.
If you are done configuring the device, enter
Configuring the IPLC Base Module at Node C
This procedure describes how to configure the IPLC base module in slot 8 of Node C in
this example.
Before you start this procedure, be sure to complete the tasks described in the
on page 60 section of this example.
To configure the IPLC base module in slot 8 of Node C:
Specify the slot location of the IPLC base module in Node C and access the IPLC
1.
configuration hierarchy.
[edit]
user@host# edit chassis fpc 8
Configure wavelength 1561.01 on port 0 of the IPLC base module to be switched to
2.
optical interface et-10/0/0.
[edit chassis fpc 8 optical-options]
user@host# set wavelength
Configure wavelength 1560.20 on port 1 of the IPLC base module to be switched to
3.
optical interface et-10/0/1.
[edit chassis fpc 8 optical-options]
user@host# set wavelength 1560.20 switch et-10/0/1
Configure wavelength 1554.54 on port 8 of the IPLC base module to be switched
4.
to optical interface et-10/0/2.
[edit chassis fpc 8 optical-options]
user@host# set wavelength 1554.54 switch et-10/0/2
Configure wavelength 1556.15 on port 6 of the IPLC base module to be switched to
5.
optical interface et-10/0/3.
[edit chassis fpc 8 optical-options]
user@host# set wavelength 1556.15 switch et-10/0/3
Confirm the configuration of the IPLC module located in slot 8 of Node C. If the command
output does not display the intended configuration, repeat the instructions in this
procedure to correct the configuration.
[edit chassis fpc 8 optical-options]
commit from configuration mode.
optical-options
1561.01 switch et-10/0/0
"Topology"
69