Juniper PTX3000 IPLC Features Manual page 39

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
[edit]
user@host# edit chassis fpc
For example, if the IPLC module resides in slot 1, enter the following:
[edit]
user@host# edit chassis fpc 1 optical-options
Specify the wavelength you want to support.
2.
[edit chassis fpc 1 optical-options]
user@host# set wavelength
For example, to support wavelength 1550.12, enter:
[edit chassis fpc 1 optical-options]
user@host# set wavelength 1550.12
NOTE: You can only specify the wavelengths listed here wavelength. If
you enter an unsupported value you are prompted with an error message.
Verify that the configuration. For example:
3.
[edit chassis fpc 1 optical-options]
user@host# show
wavelength 1550.12 {
}
If the configuration is correct, save it.
4.
[edit chassis fpc 1 optical-options]
user@host# commit
Complete your configuration by configuring the port to switch the wavelengths to an
5.
optical interface on the local or remote chassis. See,
Photonic Line Card to Switch Wavelengths to Local or Remote Optical Interfaces" on
page 29.
Configuring the Integrated Photonic Line Card to Switch Wavelengths to Local or
Remote Optical Interfaces on page 29
Bypassing a Wavelength on page 25
Integrated Photonic Line Card Base and Expansion Module Overview on page 3
Understanding the Integrated Photonic Line Card Architecture on page 6
Chapter 3: Configuring Integrated Photonic Line Card Nodes
slotoptical-options
nm
"Configuring the Integrated
23