Juniper PTX3000 IPLC Features Manual page 80

PTX3000 Integrated Photonic Line System Feature Guide
CLI Quick
Configuration
Step-by-Step
Procedure
64
To quickly configure the IPLC modules in this example, copy the following commands
into a text file, remove any line breaks, and then paste the commands into the CLI at the
hierarchy level.
[edit]
set chassis fpc 1 optical-options wavelength 1556.15 switch et-12/0/3
set chassis fpc 1 optical-options wavelength 1556.96 switch et-12/0/2
set chassis fpc 1 optical-options wavelength 1560.20 switch et-12/0/1
set chassis fpc 1 optical-options wavelength 1561.01 switch et-12/0/0
set chassis fpc 2 optical-options wavelength 1554.54 switch et-8/0/4
set chassis fpc 2 optical-options wavelength 1556.15 wss-express-in
set chassis fpc 2 optical-options wavelength 1560.20 switch et-6/0/2
set chassis fpc 2 optical-options wavelength 1561.01 switch et-6/0/1
set chassis fpc 2 optical-options express-in fpc 3
set chassis fpc 3 optical-options wavelength 1556.15 wss-express-in
set chassis fpc 3 optical-options wavelength 1556.96 switch et-8/0/3
set chassis fpc 3 optical-options wavelength 1560.20 switch et-8/0/2
set chassis fpc 3 optical-options wavelength 1561.01 switch et-6/0/0
set chassis fpc 3 optical-options express-in fpc 2
set chassis fpc 8 optical-options wavelength 1554.54 switch et-10/0/2
set chassis fpc 8 optical-options wavelength 1556.15 switch et-10/0/3
set chassis fpc 8 optical-options wavelength 1560.20 switch et-10/0/1
set chassis fpc 8 optical-options wavelength 1561.01 switch et-10/0/0
Configuring the IPLC Base Module at Node A
This procedure describes how to configure the IPLC base module in slot 1 of Node A in
this example.
Before you start this procedure, be sure to complete the tasks described in the
on page 60 section of this example.
To configure the IPLC base module in slot 1 of Node A:
Specify the slot location of the IPLC base module in Node A and access the IPLC
1.
configuration hierarchy.
[edit]
user@host# edit chassis fpc 1
Configure wavelength 1561.01 on port 0 of the IPLC base module to be switched to
2.
optical interface et-12/0/0.
[edit chassis fpc 1 optical-options]
user@host# set wavelength
Configure wavelength 1560.20 on port 1 of the IPLC base module to be switched to
3.
optical interface et-12/0/1.
[edit chassis fpc 1 optical-options]
user@host# set wavelength 1560.20 switch et-12/0/1
Configure wavelength 1556.96 on port 5 of the IPLC base module to be switched
4.
to optical interface et-12/0/2.
optical-options
1561.01 switch et-12/0/0
Copyright © 2018, Juniper Networks, Inc.
"Topology"