Juniper PTX3000 IPLC Features Manual page 77
Packet transport router integrated photonic line system
Hide thumbs
Also See for PTX3000 IPLC:
- Quick start manual (48 pages) ,
- Hardware manual (174 pages) ,
- Quick start manual (37 pages)
Table of Contents
Advertisement
Chapter 8: Example: Configuring the PTX3000 Integrated Photonic Line System in a Metro Linear Packet Optical Network
Copyright © 2018, Juniper Networks, Inc.
This procedure describes how to configure Junos OS for the IPLC modules. This is not a
complete configuration and does not include full instructions for configuring the router
or the associated line cards. Before you start this procedure, complete the following
hardware and software tasks on the PTX3000 router:
Install the IPLC modules, associated line cards, and PICs into the PTX3000 chassis so
that the hardware configuration matches what is shown in
need to make changes to the positions of the cards in the chassis, adjust the FPC
numbers referenced in
Figure 5 on page 60
BEST PRACTICE:
Node B into the same FPC/PIC slot pair on the PTX3000 chassis. In this
example the IPLCs at Node B are located in FPC slots 2 and 3.
Configure the associated wavelengths on the interfaces of the PTX3000 by using the
following procedure:
Specify the interface to configure.
1.
[edit]
user@host# edit interfaces interface-name]
For example:
[edit]
user@host# edit interfaces et-6/0/0]
Specify the wavelength value supported on the interface.
2.
[edit interfaces et-6/0/0]
user@host# set wavelength
NOTE:
Be sure to specify wavelength values on each interface as shown
in
Figure 5 on page
that you enter a value supported on the IPLC. For information on the
wavelengths supported by the IPLC, see
Photonic Line Card Architecture" on page
Make all connections to and from the PICs in the PTX3000 chassis to the
Drop
ports on front panel of each IPLC node as shown in
Connect your fiber pairs to the
IPLC node as shown in
Figure 5 on page
For simplicity,
Figure 5 on page 60
IPLC nodes.
On Node B, connect the two IPLC modules together using the
on the front panel of the IPLC as shown in
and configure them accordingly.
We recommend that you place the two IPLC modules at
60. If you must adjust the wavelength values, make sure
"Understanding the Integrated
6.
and
ports on the front panel of each
Line IN
Line OUT
60.
does not show the optical ILAs between the three
Figure 5 on page
Figure 5 on page
60. If you
and
Add
Figure 5 on page
60.
and
ports
PT IN
PT OUT
60.
61
Advertisement
Table of Contents
Troubleshooting
