Figure 6: Example Topology And Configuration - Juniper PTX3000 IPLC Features Manual

PTX3000 Integrated Photonic Line System Feature Guide
Configuration
CLI Quick
Configuration
74
Topology
Figure 6 on page 74 shows the topology for this example. At Site A, there is a PTX3000
router with an IPLC module installed in FPC slot 3. The IPLC module at Site A is the anchor
for the OSC. Three optical inline amplifiers configured as: ILA 0, ILA 1, and ILA 2 connect
Site A to Site B, where another PTX3000 is running an IPLC module. The IPLC module
at Site B is specifically configured as a non-anchor IPLC.
This topology also includes an example of configuring threshold crossing alerts (TCA)s
on the optical ILAs through the Junos OS CLI on the PTX3000 at Site A.
For this example, it is irrelevant what optical signals you are passing over the line system.
However, the line system must be up and operational.

Figure 6: Example Topology and Configuration

SITE A
PTX3000
Integrated Photonic
Line System
IPLC
Anchor
MAC address: aa bb cc dd ee ff
IP address: 10.0.0.10/24
To configure OSC communication for the PTX3000 integrated photonic line system and
optical ILAs in the amplifier chain, perform these tasks:
Configuring the PTX3000 Integrated Photonic Line System at Site A and the Optical
ILAs in the Amplifier Chain on page 75
To quickly configure this example, copy the following commands, paste them into a text
file, remove any line breaks, change any details necessary to match your network
configuration, and then copy and paste the commands into the CLI at the
level.
ILA 0 ILA 1
Direction of the optical signal
ILA0 IP address: 10.0.0.11/24
edfa-a-b tca-input-power-high enable-tca threshold 2
edfa-a-b tca-pump1-temperature-low enable-tca threshold 19
edfa-a-b tca-pump2-temperature-low enable-tca threshold 19
edfa-a-b tca-pump2-temperature-high enable-tca threshold 31
edfa-b-a tca-pump1-temperature-low enable-tca threshold 20
osc-a osc-tx-power-high-tca enable-tca threshold 5
osc-b osc-tx-power-high-tca enable-tca threshold 4
ILA 1 IP address: 10.0.0.12/24
edfa-a-b tca-pump1-temperature-low enable-tca threshold 19
voa-a tca-attenuation-high enable-tca threshold 20
osc-a osc-tx-power-high-tca enable-tca threshold 4
ILA 2
IP address: 10.0.0.13/24
osc-a osc-tx-power-high-tca enable-tca threshold 4
SITE B
PTX3000
ILA 2
Integrated Photonic
Line System
IPLC
No Anchor IPLC
MAC address: ab cd ef gh ff dc
IP address: 10.0.0.14/24
[edit] hierarchy
Copyright © 2018, Juniper Networks, Inc.