Juniper PTX3000 IPLC Features Manual page 86

PTX3000 Integrated Photonic Line System Feature Guide
Verification
Purpose
Action
70
user@host# show
wavelength 1554.54 {
switch {
et-10/0/2;
}
}
wavelength 1556.15 {
switch {
et-10/0/3;
}
}
wavelength 1560.20 {
switch {
et-10/0/1;
}
}
wavelength 1561.01 {
switch {
et-10/0/0;
}
}
If you are done configuring the device, enter
Confirm that the configuration is working properly.
Verifying the Topology of Each IPLC Node on page 70
Verifying the Topology of Each IPLC Node
Verify the topology of each IPLC node.
Run the
show chassis fpc optical-properties topology
level at each IPLC node and verify that the following fields match the values listed in
Table 8 on page 62.
Port/Wavelength —Verify that this field lists the proper wavelength values and IPLC
port numbers for each node in this example.
—Verify that the values for this field match what is listed in
State
for the mode value of each IPLC port for each node in this example.
—If the wavelength is being switched, verify that this field lists the correct
Connected To
interface the wavelength is being switched to.
Verify the topology of each IPLC node.
For example, at IPLC Node A, enter the following.
1.
user@host>show chassis fpc optical-properties topology detail fpc-slot 1
IPLC Topology Information
Wavelength(nm) / Port / Frequency(THz)
from configuration mode.
commit
command with the
Table 8 on page 62
State
Copyright © 2018, Juniper Networks, Inc.
output
detail
Connected