Configuring The Optical Ila Identification Number - Juniper PTX3000 IPLC Features Manual
Packet transport router integrated photonic line system
Hide thumbs
Also See for PTX3000 IPLC:
- Quick start manual (48 pages) ,
- Hardware manual (174 pages) ,
- Quick start manual (37 pages)
Table of Contents
Advertisement
Chapter 6: Configuring the Optical Supervisory Channel in the Amplifier Chain When Using the Optical Inline Amplifier
Related
Documentation
Configuring the Optical ILA Identification Number
Copyright © 2018, Juniper Networks, Inc.
Specify the MAC address for the IPLC OSC management interface.
2.
[edit chassis fpc 3 optical-options amplifier-chain]
user@host# set osc-mac osc-mac
Verify the configuration.
3.
[edit chassis fpc 3 optical-options amplifier-chain]
user@host#
show chassis fpc optical-properties amplifier-chain ila osc
Save the configuration.
4.
[edit chassis fpc 3 optical-options amplifier-chain]
user@host# commit
Understanding Optical Supervisory Channel Communication in the Amplifier Chain on
page 11Configuring the Optical Supervisory Channel Across the Amplifier Chain of the
PTX3000 Integrated Photonic Line System on page 33
Example: Configuring the Optical Supervisory Channel for the Integrated Photonic Line
System and Optical Inline Amplifier on page 73
show chassis fpc optical-properties amplifier-chain ila osc on page 468
To enable optical supervisory channel (OSC) communications and manage optical inline
amplifiers (ILA)s in the amplifier chain through the Junos CLI, you need to configure each
optical ILA with a unique number. This number identifies the optical ILA within the
PTX3000 integrated photonic line system and Junos CLI. Use this procedure when you
are using the PTX3000 integrated photonic line system with the optical ILA to enable
OSC communication across the optical network or to enable management of certain
optical ILA parameters through the Junos OS CLI.
TIP:
Remember that all communication to and from an optical ILA is through
the anchor IPLC, so when you configure any options on an optical ILA, you
must specify the FPC number in which the anchor IPLC resides.
NOTE:
To configure any other optical ILA options, use the login procedures
describe in the
Before you begin, make sure you complete the following tasks:
Configure the IPLC anchor for the amplifier chain, see
1.
of the Amplifier Chain" on page
Configure the IP address of the anchor IPLC. See,
2.
Anchor IPLC" on page
35.
Optical Inline Amplifier Hardware Guide
34.
.
"Configuring the Anchor IPLC
"Configuring the IP Address of the
37
Advertisement
Table of Contents
Troubleshooting
