Optical-Options (Iplc) - Juniper PTX3000 IPLC Features Manual

PTX3000 Integrated Photonic Line System Feature Guide

optical-options (IPLC)

Syntax
Hierarchy Level
Release Information
Description
Options
100
optical-options {
disable-edfa;
disable-osc;
expansion-card {
fpc fpc-slot;
}
express-in {
fpc fpc-slot;
}
no-disable-edfa;
no-disable-osc;
switch interface-name{
}
tca tca-identifier (enable-tca | no-enable-tca) (threshold number | threshold-24hrs number)
;
wavelength nm{
wss-express-in fpc-slot;
}
}
}
[edit chassis chassis fpc slot]
Statement introduced in Junos OS Releases 15.1F6 and 17.1R1 on PTX3000 integrate
photonic line system.
Configure the settings for the integrated photonic line card (IPLC). The options under
this statement enables you to increase the IPLC channel capacity to 64 channels,
configure express in and out traffic from another IPLC base module, create a single
two-degree IPLC node, switch express traffic to optical interfaces in the local or remote
chassis, optically bypass channels, and fine-tune performance monitors.
slot—Specify the slot number the IPLC resides in.
Range: 0 through 15
disable-edfa—Disable both erbium-doped fiber amplifiers on the IPLC. Disabling the
erbium-doped fiber amplifiers on the IPLC is required as a preliminary step whenever
the you need to disconnect the fiber span from the
troubleshooting.
disable-osc—Disable the optical supervisory channel laser.
no-disable-edfa—Enable both erbium-doped fiber amplifiers on the IPLC. By default,
both erbium-doped fiber amplifiers are enabled.
no-disable-osc—Enable the optical supervisory channel. By default, the optical supervisory
channel is enabled.
and ports for
Line IN Line OUT
Copyright © 2018, Juniper Networks, Inc.