Juniper PTX3000 IPLC Features Manual page 66

PTX3000 Integrated Photonic Line System Feature Guide
50
To configure a TCA, specify the TCA low and high thresholds and then enable the TCA.
This example enables the
performance monitor.
OSC RX power
To configure a TCA:
Navigate to the IPLC TCA configuration. For example:
1.
[edit]
user@host# edit chassis fpc 2 optical-options tca
Configure the 15-minute, low threshold. For example:
2.
[edit chassis fpc 2 optical-options tca]
user@host# set osc-rx-power-low-tca threshold -46 enable-tca
Configure the 15-minute, high threshold. For example:
3.
[edit chassis fpc 2 optical-options tca]
user@host# set osc-rx-power-high-tca threshold 7 enable-tca
Configure the 24-hour, low threshold. For example:
4.
[edit chassis fpc 2 optical-options tca]
user@host# set osc-rx-power-low-tca threshold-24hrs -46 enable-tca
Configure the 24-hour, high threshold. For example:
5.
[edit chassis fpc 2 optical-options tca]
user@host# set osc-rx-power-high-tca threshold-24hrs 7 enable-tca
Verify the configuration.
6.
[edit chassis fpc 2 optical-options tca]
user@host# show
osc-rx-power-high-tca {
enable-tca;
threshold 7;
threshold-24hrs 7;
}
osc-rx-power-low-tca {
enable-tca;
threshold -46;
threshold-24hrs -46;
}
Save your configuration.
7.
[edit chassis fpc 2 optical-options tca]
user@host# commit
You can use the following commands to view information about performance monitors
8.
and TCA alarms:
and
osc-rx-power-high-tca
TCA in the
osc-rx-power-low-tca
Copyright © 2018, Juniper Networks, Inc.