Table 7: States For Cfeb Leds - Juniper M10i Hardware Manual

I 2 C/EEPROM containing the serial number and revision level
Two 512-KB boot flash EPROMs (programmable on the board)
One PowerPC 8245 integrated processor
Three LEDs—A green LED labeled
labeled
MASTER
states.
Power off button—Prepares the CFEB for removal from the router when pressed.
Ejector levers—Control the locking system that secures the CFEB in the chassis.
NOTE: For specific information about CFEB components (for example, the amount
of SDRAM), issue the
Figure 4: CFEB

Table 7: States for CFEB LEDs

Label Color
Green
OK
Red
FAIL
Blue
MASTER
OK
indicate CFEB status.
show chassis cfeb
State Description
On steadily CFEB is running normally.
Blinking CFEB is starting up.
On steadily CFEB is not operational or is in reset mode.
On steadily CFEB is functioning as master.
Chapter 2: Hardware Component Overview
, a red LED labeled , and a blue LED
FAIL
on page 13 describes the LED
Table 7
command.
Compact Forwarding Engine Board (CFEB)
13