M7I Cfeb And Cfeb-E Leds; Table 40: States For Cfeb Or Cfeb-E Leds - Juniper M7i Hardware Manual

Related
Documentation

M7i CFEB and CFEB-E LEDs

Related
Documentation
Copyright © 2019, Juniper Networks, Inc.
MLPPP
MLFR
cRTP
Multiclass MLPPP
RPM
NOTE: You can enable either Layer 2 or Layer 3 services on the MultiServices
Module, but you cannot enable both Layer 2 and Layer 3 services concurrently.
The configuration for these services comprises a series of rules that you can arrange in
order of precedence as a rule set. Each rule follows the structure of a firewall filter, with
a statement containing input or match conditions and a
from
actions to be taken if the match conditions are met.
For information about configuring interfaces on the MSM, see the Junos OS Services
Interfaces Library for Routing Devices.
M7i CFEB and CFEB-E LEDs on page 69
M7i and M10i Packet Forwarding Engine Architecture on page 5
M7i Router Description on page 3
M7i Router Physical Specifications on page 74

Table 40: States for CFEB or CFEB-E LEDs

Label Color
Green
OK
Red
FAIL
MASTER Blue
M7i Compact Forwarding Engine Board (CFEB) and Enhanced Compact Forwarding
Engine Board (CFEB-E) Description on page 63
Chapter 8: Switch Fabric Components and Descriptions
State Description
On steadily CFEB/CFEB-E is running normally.
Blinking CFEB-E is starting up
Off CFEB/CFEB-E is offline.
On steadily CFEB/CFEB-E is not operational or is in reset mode.
Off CFEB/CFEB-E is functioning properly.
On steadily CFEB/CFEB-E is functioning as master. On an M7i
router, this LED is always lit.
statement containing
then
69