Interference With Sdi Ports; Interference With The Spre Code; Interference With The Attendant Extension Number - Nortel Meridian 1 Planning, Installation And Operating Instructions

Page 424 of 536

Interference with SDI ports

Interference with the SPRE code

Interference with the attendant extension number

553-3121-210 Standard 3.0
Chapter 24 – Changing pre-programmed data
Five SDI/ESDI ports are pre-programmed. Ports 8 and 9 are associated with
the Meridian Mail option, and ports 0, 1 and 2 are associated with the Small
System Controller (SSC) card. Port 0 is associated with SSC card and cannot
be removed. Any of the remaining ports can be removed using LD 17 as
follows.
LD 17
REQ CHG
TYPE CFN
ADAN OUT TTY X
If the pre-programmed SPRE code interferes with the programming required
for the Option 11C Compact system, use LD 15 to remove it. For customer 0
enter the following in response to the SPRE prompt:
LD 15
SPRE Xy
Note: To define a new SPRE code, type a space and enter the new
number.
The attendant extension number cannot be removed from the system;
however, the default number can be replaced with another number.
LD 15
REQ CHG
TYPE CDB
CUST x
.
ATDN xxxx
January 1999
"X" = the TTY that you are removing
"y" = the value of the SPRE code
CHG = Change
CDB = Customer Data Block
"x" = Customer number
"xxxx" = the new extension number