Nortel Meridian 1 Planning, Installation And Operating Instructions page 235

Hide thumbs Also See for Meridian 1:
Table of Contents

Advertisement

Page 216 of 536
553-3121-210
Standard 3.0
Chapter 20 — Meridian Mail Compact Option installation and maintenance
Table 30
Tandberg Panther SE2000 tape drive status
Light status
Steady
Flashing
Off
Procedure 44
Removing the external tape drive
For systems not equipped with a permanently installed external tape drive, the
Meridian Mail Compact Option representative is responsible for all software
procedures that require a tape drive and should, therefore, include a tape drive
as part of the standard equipment.
To remove the external tape drive, follow these steps:
1
Refer to the procedure
to courtesy down Meridian Mail Compact Option.
2
Turn off the power to the tape drive and unplug it.
3
Detach the grounding wire from the Meridian Mail Compact Option
cabinet.
4
Unplug the SCSI cable from the Meridian Mail Compact Option card.
5
To reset Meridian Mail Compact Option, follow
—————————— End of Procedure ——————————
January 1999
Description
The tape is in and idle.
The tape is in and spinning.
The tape is out or the power is off.
"Installing the external tape drive" on page 211
Procedure
40.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Option 11c compact

Table of Contents