Card Slot Assignments - Nortel Meridian 1 Planning, Installation And Operating Instructions

Card slot assignments

Option 11C Compact
Chapter 3 — System and site requirements
A card slot allocation plan showing circuit card to Peripheral Equipment (PE)
slot assignments (Figures
NTMW01 Small System Controller (SSC)
The NTMW01 Small System Controller (SSC) card must be installed in the
main cabinet in the CPU slot. It can be equipped with an NTDK22 10m Fiber
Expansion Daughterboard to provide a connection to an expansion cabinet.
NTMW02 Meridian Mail CPU card
The NTMW02 Meridian Mail CPU card must be installed in the main cabinet
in the MMail slot. It can be equipped with up to two NTMW03 4 Port Mail
DSP Daughterboards. Each daughterboard supports four voice mail ports.
NTMW04 DTI/PRI card
The NTMW04 DTI/PRI card must be installed in the main cabinet in any of
slots 1 & 2, 3 & 4 or 5 & 6 (upper PE slots).
The NTMW04 card is recognized by the system as the odd-numbered card
when installed as follows:
• card 1, when installed in slot 1 & 2
• card 3, when installed in slot 3 & 4
• card 5, when installed in slot 5 & 6
Note: This card cannot be installed in the lower PE slots of the main
cabinet (slots 7 through 9) or in any slot of an expansion cabinet.
Line cards
The following Peripheral circuit cards can be installed in any slot in the main
and expansion cabinets:
• NTMW05 24 Port Digital Line Card
• NTMW06 16 Port Analog Line Card
Combined Trunk and Line card
The NTMW07 Analog Trunk/Line Card can be installed in any upper PE
slots of the NTMW08 cabinet (main and expansion).
7, 8 and 9) should be prepared for each cabinet.
Planning, Installation, Fault Clearing and CCBR Guide
Page 41 of 536