How To Clear Faults - Nortel Meridian 1 Planning, Installation And Operating Instructions

How to clear faults

To clear faults in the Option 11C Compact system, follow the steps below:
1 Classify the fault by the indicators present (see the section
indicators" on page
clear them in the following order:
Note: Always clear possible power faults then Common Equipment
faults before any other type of fault.
2 Go to the section for clearing the type of fault identified. There is a
section for each type of fault listed above (for example,
power faults" on page
to a symptom listed in the section.
3 Go through the procedure for clearing each possible cause of the
problem until the fault is cleared.
4 When the fault is corrected, follow the instructions in "
maintenance procedure" on page 534
operation.
—————————— End of Procedure ——————————
Option 11C Compact
Chapter 25 — Fault locating and clearing
460. When there are indications of multiple faults,
• "Clearing power faults" on page 469
• "Clearing Common Equipment faults" on page 474
• "Clearing Network faults" on page 481
• "Clearing Peripheral Equipment faults" on page 495
• "Clearing trunk faults" on page 503
• "Clearing attendant console faults" on page 510
• Telephone faults
469. As closely as possible, match the problem
Planning, Installation, Fault Clearing and CCBR Guide
Page 459 of 536
"Clearing
"Final
to completely restore normal
"Fault