Removing Telephone Models; Creating Trunk Models And Changing Route Access Codes; Creating Trunk Models - Nortel Meridian 1 Planning, Installation And Operating Instructions

Removing telephone models

Creating trunk models and changing route access codes

Creating trunk models

Option 11C Compact
Chapter 24 – Changing pre-programmed data
Use LD 10 to remove analog telephone models and LD 11 to remove digital
telephone models. Respond as follows to the prompts in either overlay:
LD 10 or LD 11
REQ OUT
TYPE XXXX M
CUST 0
MODL YYY
Use overlay program 14 to create trunk models different from the default
models provided in the system software. Route access codes are changed
using the administration telephone.
For additional assistance when creating trunk models, refer to the Option 11c
Compact Software Guides that are shipped with every system.
To create a new trunk model, load LD 14 and type in the following commands
on the TTY:
LD 14
REQ NEW
TYPE aaa M
MODL YYY
"XXXX" = telephone type for the model
you are removing (Example: 500, 2006,
2317, 2216, 3000, etc.)
"YYY" = the model number associated
with the telephone type you are removing
(Valid range is 1-127).
"aaa" = the type of trunk that you are
creating (TIE, COT, WATS, and so on).
"YYY" = the model number of the trunk being
created (between 1 - 127)
Planning, Installation, Fault Clearing and CCBR Guide
Page 431 of 536