Nortel Meridian 1 Planning, Installation And Operating Instructions page 194

Chapter 17 – Connecting the telephones and attendant console
Telephone without a character display
Procedure 25 describes how to activate a default model on a telephone with a
character display.
Procedure 25
Activating the telephone
1 Plug the telephone set into the jack and wait 20 seconds.
Note: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using the
Modular Telephone Relocation feature.
2 Press the pound key (#) to select the default model.
3 Press the pound key again to select the default extension
number.
A short, high-pitched beep lasting four seconds is heard followed by
silence (relocation tone). If the extension number is already in use by
another telephone, three beeps are heard followed by continuous dial
tone (special dial tone).
To accept the default extension number press the pound key.
To select a new extension number, enter an extension number
and press the pound key.
If the extension number is not available for use, a fast, high-pitched
broken tone (overflow tone) is heard. (This happens when an
extension number is manually chosen or when extension numbers are
entered for additional keys. A default extension number will not be
offered if it is not available). Repeat Step 3 and enter a new extension
number.
Note: If other keys require secondary extension numbers, you are
prompted until all the required extension numbers for the model are
entered. These extension numbers cannot be defaulted. You are
prompted for each additional extension number with three beeps
followed by continuous dial tone (special dial tone). When an extension
number is being programmed, the lamp associated with that number
on the telephone is lit.
—————————— End of Procedure ——————————
Option 11C Compact Planning, Installation, Fault Clearing and CCBR Guide
Page 175 of 536