Installing The Software - Nortel Meridian 1 Planning, Installation And Operating Instructions

Chapter 16 – Starting up and testing the system

Installing the software

Procedure 20 describes how to use the Software Installation Program install
the system software.
Procedure 20
Software Installation Procedure
1 Observe the terminal screen.
SOFTWARE INSTALLATION PROGRAM
message appears.
2 Observe the terminal screen.
If
Current system time and date: 00:00:00 -- 00/00/00
message appears, proceed with
If
Software Installation Main Menu
message appears, proceed with
3 Set the system Time and Date.
Note: The Time and Date prompt appears only when the Install Setup
Program detects a system Year Date that is not in the range of
1995-2095.
4 Select item 1 or 4 from the Main Menu.
If you have just completed
If you have just completed
Software Installation Main Menu
1. New System Installation - From Software
Daughterboard
2. System Upgrade
3. Utilities
4. New System Installation - From Software Delivery
Card
[q]uit, [h]elp or [?], <cr> - redisplay
Option 11C Compact
Step 3
Step 4
Procedure 18 on page
Procedure 19 on page
Planning, Installation, Fault Clearing and CCBR Guide
Page 149 of 536
146, select item 1.
147, select item 4.