Archiving And Removing Databases; Introduction; How To Use Archive Feature - Nortel Meridian 1 Planning, Installation And Operating Instructions

Archiving and removing databases

Introduction

How to use archive feature

Option 11C Compact
This section describes how to use the Archive feature to:
• archive a new customer database
• list the databases that are archived
• remove existing archived databases.
The database can be defined in an off-site lab environment and saved
(archived) on a Software Delivery (PCMCIA) card until it is required. It can
then be loaded in the customer's system using the Software Delivery card.
The customer database must first be defined and loaded into the flash ROM
on the NTMW01 Small System Controller (SSC) card before it can be
archived on the Software Delivery card.
Methods used to define and load customer databases are described in the
following sections:
• "Software upgrade to a new release or issue" on page 305
• "Feature Set and ISM Parameters upgrade" on page 319
Summary of steps
The steps to archive a customer database are summarized in the following list.
They consist of:
• Checking to make sure the correct Software Delivery card is installed.
• Selecting the Utilities function.
• Selecting Archive option.
Using the archive feature
The following procedure describes how to use the archive feature to list, add
and remove customer databases.
Chapter 22 — Upgrading software
Planning, Installation, Fault Clearing and CCBR Guide
Page 337 of 536