Conflicts With Call Park Extension Numbers; Conflicts With Sdi Ports - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Conflicts with Call Park extension numbers

System call park extension numbers are preprogrammed for the Central
Answering Position. (For some countries, the default call park extensions are
listed in Table 74 on page 404.) To remove this data from the system, load
LD 50 and respond to the prompts as follows:
LD 50
REQ
TYPE
CUST
SPDN
Repeat for each Call Park extension you wish to remove.

Conflicts with SDI ports

Five SDI/ESDI ports are preprogrammed on the Small System. Ports 8 and 9
are associated with the Meridian Mail card option, and ports 0, 1, and 2 are
associated with the NTDK20 Small System Controller (SSC) card. You
cannot remove port 0; however, you can remove any of the remaining ports
using LD 17 as follows.
LD 17
REQ
TYPE
ADAN
Changing preprogrammed data
OUT
CPK
0
XXXX where "XXXX" = value of Call Park extension
CHG
CFN
OUT TTY X where "X" = the TTY that you are
removing
Small System
Page 477 of 562
Installation and Configuration