Terminal Setup - Nortel Meridian 1 Planning, Installation And Operating Instructions

Chapter 15 – Installing and connecting SDI and Ethernet ports

Terminal setup

Option 11C Compact
2 Connect the NTAK1118 SDI cable to a TTY terminal.
Note: A Modem Eliminator is required to connect to a terminal.
3 If the system is to be accessed remotely, connect the SDI cable to
the system modem.
4 Connect the modem to an outside line.
5 Test the modem for proper operation once the system is
operating.
—————————— End of Procedure ——————————
Setup values are given in
to set up the terminal.
Procedure 16
Setting up the terminal
1 Turn on the power for the terminal
2 Enter setup mode by pressing the <SETUP> key located on the
top row of the special function keys.
The current setup values are displayed.
3 Change the value in each field on each setup screen as
necessary.
Use the following keys to view and change setup values:
Key
Arrow key
<Enter>
<Next Screen>
<Prev Screen>
Tables 14, 15 and 16. Use the following procedure
Function
Move from field to field
Scroll through possible values or cause
requested action to take place (depends on
type of field)
Move to next setup screen
Move back screen
Planning, Installation, Fault Clearing and CCBR Guide
Page 131 of 536