Table of Contents
Advertisement
Deployment tool
Charging the deployment tool battery
Charge the deployment tool battery for at least six hours before using.
Caution:
Equipment Damage
Use the Avaya battery charger. This charger is a separately ordered item. Failure to use an
automatic shutoff battery charger can damage the battery.
Do not use the battery supplied with the CT2 deployment tool. The CT2 and DECT batteries
are not interchangeable.
The deployment tool charger has the following components:
• battery charger (must be ordered separately)
• battery charger cable
The following figure shows the charger for the deployment tool.
Figure 53: Deployment tool battery charger
Charging the deployment tool battery
1. Set up the deployment tool battery charging equipment.
2. Charge the deployment tool battery.
3. Remove the deployment tool battery from the charger after it is charged.
208
SIP DECT Fundamentals
Remove the deployment tool battery, charger, and charger cord from the yellow
case.
Connect the charger cord plug into the battery. Connect the red alligator clip to the
positive lead of the charger and the black clip to the negative lead of the charger.
Connect the battery charger to the AC mains.
The battery must charge for at least 6 hours.
Comments? infodev@avaya.com
October 2012
Advertisement
Table of Contents
