Table of Contents
Advertisement
G.729 daughterboard and DAP wall mounting
Figure 42: 4720 mounted horizontally
Important:
The antenna position can be changed once. Do not change the antenna position after the
initial change.
1. Remove the two screws from the rear side of the cabinet.
2. Open the cabinet carefully. Ensure that you shift the cover of the antenna carefully
3. Remove the antenna cover from the 4720 DAP cover.
4. Carefully bend the antennas to position them vertically, as shown in
178
SIP DECT Fundamentals
from the antenna.
Antennas carefully into vertical position
Figure 43: Bend Antennas carefully into vertical position
Comments? infodev@avaya.com
on page 178.
Figure 43: Bend
October 2012
Advertisement
Table of Contents
