Avaya CS 1000 Fundamentals page 98

System configuration
98 SIP DECT Fundamentals
the user password sent by SIP DECT to the SIP Line registrar contains
the additional symbols and the handset DN. When you add a UEXT on
the Call Server, ensure that you enter the correct user name at the SIPU
prompt (SIP DECT handset DN) and password at the SCPW prompt (DN
or combination of entered symbols and DN) For example, if you enter %s
for user and 12%s34 for password, the DAP attempts to register DECT
handset 5001 as user 5001@domain with password 12500134.
The password is encrypted, and does not appear in a readable form if you reopen
the SIP settings tab.
To change the password, enter a new value in the Pswd field, save the system, and
restart all connected DAPs.
All required SIP Settings are set automatically to required values according to CS
1000 SIPL configuration and you should not change them. The optional settings
you can configure are the following (Configuration Settings tab):
a. Select the check box for max_intern_dnr_len and enter the maximum
number of digits in the internal DNs. DNs that contain more digits than
configured for this parameter are defined as external. Depending on
DECT handset capabilities, different ringing melodies can be used for
internal and external calls.
b. If your Communication System supports Music on hold based on IP
Media services select the check box sdp_MoH and select yes.
c. Some communication systems (e.g. MS Office Communication Server
(OCS R2)) and devices may require sending DTMF tones in RTP stream.
To enable this option select the check box sdp_DTMF_rfc2833 and
select yes.
Note:
In this case accessing the voice mail box from DECT handset, using
automatically logging in (when your voicemail system login and
password are entered in the handset settings), is not possible.
d. Select the check box for t_overlap_first and enter the value (in seconds)
to define how long the DAP waits for the user to dial the first digit. If no
new digit is dialed within the specified period of time, the DECT handset
goes on-hook automatically.
e. Select the check box for t_overlap_final and enter the value (in
seconds) to define how long the DAP waits for the user to dial the next
digit of the number (when the user has already dialed in at least one
digit). If no new digits are dialed within the specified period of time, the
dialed number is called.
Note:
This setting is applied to the predial mode as well.
f. Select the check box for sdp_payload_size and enter the value (in
milliseconds) to define the SDP (Session Description Protocol) offer
payload size.
Comments? infodev@avaya.com
October 2012