Avaya CS 1000 Fundamentals page 53

Cell contour arcs must pass near the cell boundary of adjacent cells. For an example,
see
Figure 23: Example of deployment for cell center 1C2
Use the following procedure to mark cell contours, centers, and boundaries at the far end of
the intended coverage area.
Demarcating additional cell contours, centers and boundaries at the far end of
the building
Repeat the procedures
labeling new critical points
SIP DECT Fundamentals
Figure 23: Example of deployment for cell center 1C2
Identifying critical points on the floor
on page 52 as necessary to mark new cell boundaries at
System deployment
on page 53.
on page 45 toMarking and
October 2012 53