Uninstalling Dap Controller Software - Avaya CS 1000 Fundamentals

Important:
If you use the built-in DHCP and TFTP servers, do not deactivate the DAP Controller
software. In this case, deactivating the DAP Controller software can interrupt service
when a DAP restarts, for instance during a power interruption or during a firmware
upgrade.
If you disconnect your DAP controller PC from the network, you must first deactivate SIP DECT
services.
Deactivating SIP DECT services
1. Start DAP Configurator
2. In the IP DECT Configurator main window, click Activate/Deactivate/System
3. Click Deactivate All (indicated in the following figure) to stop all enabled services
4. After you deactivate the system, click Exit.

Uninstalling DAP Controller software

Remove the DAP Controller software,
SIP DECT Fundamentals
Status.
and programs.
DAP Controller deactivation
October 2012 167