Table of Contents
Advertisement
5. Snap the cover of the C4710E DAP to the rear side, to close the DAP cabinet.
6. Unlock the cabinet, and open the cabinet door.
7. Remove the foam cover and foam blocks from the cabinet.
8. Mount the swivel, and route the incoming cable through the swivel.
9. Verify that the cable fits snugly into the waterproof inlet housing.
10. Connect the incoming cable to the connection box that is delivered with the outdoor
11. Connect the CAT5 cable that is inside the outdoor cabinet to the connector box.
SIP DECT Fundamentals
Installing a C4710E DAP in an external housing with an external antenna
Fasten the cabinet by mounting the two screws into the two holes in the rear side
of the cabinet.
cabinet.
October 2012
231
Advertisement
Table of Contents
