Configuration - Avaya CS 1000 Fundamentals

DECT Messaging and Location Service

Configuration

Prerequisites
DMLS requires DAP Controller to always be active.
Configuring DECT Messaging and Location Service
The following configuration is required to enable interworking between DMLS and SIP DECT
system (DAP Controller):
1. Add a new system using a right button of the mouse on the field in the DECT system
2. Enter system name, SIP DECT system PARI, DAP Controller IP address, port
3. Enter the license type: Basic for messaging functionality or Location for additional
4. Enter the key and press OK.
5. If you have a location license and Ekahau software click Settings tab and enter
6. Select Service menu and click start to launch the service.
7. Create an ssh connection to the IP address, where DMLS is running, using a
Note: A tool for creating an ssh connection or any software for performing automatic operations
with DMLS is not provided.
When DMLS establishes a connection to DAP Controller and you set up a connection to DMLS,
you can send service commands according to the DMLS interface specification. Refer to Client
interface description DECT Messaging and Location Service provided with the DMLS software
package.
268 SIP DECT Fundamentals
tab.
28001, Application port (for example, 2010).
location detection functionality.
Ekahau RTLS controller IP address in the section Location Engine IP address
(default port 8552).
If the connection is established, the Link is changed to up, License status – to
Valid.
configured application port (for example, 2010).
Comments? infodev@avaya.com
October 2012