Table of Contents
Advertisement
13. Tighten the cable inlet on the swivel and make sure that the cable inlet is
14. Mount the RJ45 connector to the cable using the tool for mounting an RJ45
15. Open the 4720E box by means of removing the two screws at the rear side of the
16. Use a small pair of tongs to open the predefined holes in the 4720E cabinet.
17. Connect the RJ45 ethernet plug to the 4720E and mount the antenna cables to it.
SIP DECT Fundamentals
Note:
The cable length in the cabinet must be 20 cm (this includes the RJ45 connector
which you have to mount to the cable later on).
Note:
At the outside of the box, the cable must be led directly from the cabinet into the
building to avoid exposing the cable to lightning.
waterproof.
connector plug to a Category 5 cable. For more information on standard colour
schemes, see
Wire color coding for Category 5 cables
4720E.
Figure 78: 4720 DAP cabinet and pair of tongs
Figure 79: Detail of the 4720 DAP of predefined hole in the 4720 cabinet
Also connect the other end of the cables to the directional antenna.
Note:
Use the SMA Torque Wrench to fasten the coax nuts on the 4720E. Otherwise
you can easily damage the screw-thread.
Installing a 4720 DAP with external antennas
on page 27.
October 2012
225
Advertisement
Table of Contents
