Table of Contents
Advertisement
Site planning and hardware deployment
the other end of the building. In
1C4
Figure 24: Example of deployment for cells 1C3 and 1C4
Use the following procedure to identify new critical points.
Identifying new critical points
1. Mark critical points adjacent to a critical point and on the opposite side of the cell
2. Mark critical points inside of where the cell boundary meets the outside wall (P12,
3. Mark critical points where cell boundaries meet (P16 and P17 in
54
SIP DECT Fundamentals
on page 54, new cells are formed around cell centers IC3 and IC4.
boundary area. (critical point = P11 in
P12, P13, P14, P15, P16, P17)
The critical points must be as follows.
P13, P14, and P15 in
P15, P16, P17)
on page 55, and
new critical points (P11, P12, P13, P14, P15, P16, P17)
Comments? infodev@avaya.com
Figure 24: Example of deployment for cells 1C3 and
Figure 25: Identify new critical points (P11,
on page 55, where cell boundary area = IC2),
Figure 25: Identify new critical points (P11, P12, P13, P14,
Figure 25: Identify
on page 55.
October 2012
Advertisement
Table of Contents
