Table of Contents
Advertisement
Install the external housing
18. Close the 4720E box and mount the two screws at the rear side of the 4720E
19. Connect the RJ45 connector to the 4720 DAP (at the rear side).
20. Push the 4720E into its position in the foam.
21. Lead the coax antenna cables via the top side of the foam and determine the
22. Cut the hole for the directional antenna to the correct size, to be able to push the
226
SIP DECT Fundamentals
Figure 80: Connecting the cables to the 4720E
box.
position of the directional antenna. Note that the hole in the foam is not big enough
for the antenna. This is done on purpose, in order to allow various positions of the
direction antenna.
Figure 81: Antenna does not fit into the hole
antenna in the hole.
Figure 82: Cutting the foam to allow the antenna to fit into it, in the required position
Comments? infodev@avaya.com
October 2012
Advertisement
Table of Contents
