Avaya CS 1000 Fundamentals page 99

Basic (simple) SIP DECT configuration with Communication Server 1000 SIP Line Gateway
5. Click Apply.
Configuring DECT Settings
1. In the Settings pane, click DECT Settings.
2. In DECT Settings tab enter an eight-digit hexadecimal string for the Primary Access
3. For a Branch Office configuration, if a WAN connection between the branch offices
SIP DECT Fundamentals
Note:
SIP DECT does not support a payload size of 10 ms.
g. Select the check box for Call_waiting_indication and enter the text that
will be displayed on the screen of the handset for second incoming
call.
h. select the check box for 404 and enter the text that will be displayed on
the screen of the handset if a called user is not found.
i. Select the check box for 480 and enter the text that will be displayed on
the screen of the handset if a called user is busy.
j. Select the check box for 486 and enter the text that will be displayed on
the screen of the handset if a called user is not available.
The DECT Settings window appears.
Right Identity (PARI); 4 for example, 1F12345A.
Avaya customers usually receive unique PARIs with their DECT systems. For
information about the allocation of PARI or SARI for your DECT installation, contact
your Avaya DECT supplier. The worldwide unique PARI for your DECT system is
issued by the European Telecommunications Standards Institute (ETSI). For more
information, see http://www.etsi.org.
Important:
Ensure you enter the correct PARI. You must reinstall the DAP Controller software
and resubscribe all DECT Handsets if you change the PARI.
If you plan to configure an MSMN configuration enter an eight-digit hexadecimal
string for the Secondary Access Right Identity or SARI; for example, 1F12345F.
SARI must be the same on all systems used as MCDN sites.
and the main office is not powerful enough for voice calls using G.711 codec, select
Use G.729 when required. When you select Use G.729 when required, calls
within an office use G.711 and calls located in different offices use G.729.
Note:
The following restrictions apply:
• To use the G.729 codec, all DAPs in the SIP DECT system must support
the G.729 codec. Only DAP models 4720 and 4720E can support G.729.
For these DAP models to support G.729, you must install a G.729
daughterboard on the DAP, which is not shipped in the standard DAP
October 2012 99