Table of Contents
Advertisement
Convert SIPN/SIP3 TNs to SIPL UEXT TNs
You must convert all SIPN TNs to SIPL UEXT TNs to upgrade to a SIPL connection. You can
manually configure new values for the TNs, or you can use the SIP Line Conversion Utility
(SIPLCU) to configure values for multiple TNs. Avaya recommends that you use the SIPLCU
when you configure values for 25 or more TNs. For information about installing the SIPLCU,
see Avaya SIP Line Fundamentals, NN43001-508.
Configuring new TN values using the SIPLCU
view of the steps to convert SIPN TNs to SIPL UEXT TNs by using the SIPLCU.
Note:
The SIPLCU includes a built-in Help menu that provides detailed operating instructions for
using the utility.
Configuring new TN values using the SIPLCU
1. Connect to the CS 1000 Call Server.
2. Retrieve the current configuration details for the SIPN UEXT TNs, and store the
3. Modify the file to provide the required new details for SIPL UEXT (SIPU, ZONE,
4. Convert the TNs on the CS 1000 Call Server.
SIP DECT system upgrade
To upgrade your SIP DECT system from SIPN to SIPL connection type (through SIP Line
Gateway), perform the following:
1. Upgrade your DAP Controller to version 5.2. For more information, see
2. Select SIP on CS1000 SIPL and the required firmware package as described in the
3. Enter the Proxy IP address, which is the SIP LINE Gateway Node IP address as
4. Enter SIP settings as described in the procedure
SIP DECT Fundamentals
configuration details in a temporary file.
NDID, SCPW, HOT U DN).
Note:
For more information about UEXT configuration, see
Extension on a Call Server
controller software
on page 75.
procedureAdding a new system using the IP DECT Configurator
described in the procedure
page 96.
Convert SIPN/SIP3 TNs to SIPL UEXT TNs
on page 237 provides a high-level procedural
on page 106.
Configuring IP Settings
Configuration of Universal
on page 94.
on page 95.
Configuring SIP Settings
October 2012
DAP
on
237
Advertisement
Table of Contents
