System administration
3. Select the DAP to edit.
4. Click Edit.
5. Enter the new RPN.
6. Click OK.
Restarting a DAP
Follow this procedure to restart a DAP. This can be required if you are upgrading software, or
if a DAP is not functioning properly.
Restarting a DAP
1. Open Internet Explorer and enter the following URL in the address field: localhost/
2. Click Access points.
3. Select the DAP to restart.
4. Click Reboot.
130
SIP DECT Fundamentals
The RPN must be a hexadecimal two-digit number in the range 000 to 00F.
Wait until DAP restarts and starts working.
cds.
The DAP manager IP DECT page appears.
The DECT Access Points page appears.
The DAP restarts. It takes several minutes for the DAP to begin working again after
it restarts.
Comments? infodev@avaya.com
October 2012