Digital Operator Constants: O - YASKAWA Varispeed E7 Instruction Manual And Parameter Description

Digital Operator Constants: o

Monitor Select: o1
Con-
Name
stant
Number
o1-01 Monitor selection
Monitor selection
o1-02
after power up
Frequency units
o1-03 of reference set-
ting and monitor
o1-05 LCD-Focus
Monitor Mode
o1-06
*1
Selection
2nd Monitor
o1-07
*1
Selection
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Set the number of the 3rd. monitor
item to be displayed in the Drive
Mode (U1- ).
(Not on LCD operator.)
Sets the monitor item to be dis-
played when the power is turned on.
1: Frequency reference
2: Output frequency
3: Output current
4: The monitor item set for o1-01
Sets the units that will be set and
displayed for the frequency refer-
ence and frequency monitor.
0: 0.01 Hz units
1: 0.01% units (Maximum
output frequency is 100%)
2 to 39: rpm units (Set the motor
poles.)
40 to 39999: User desired display
Set the desired values for setting
and display for the max. output
frequency.
Sets the value that is
to be displayed at
100% excluding the
decimal point.
Sets the number of
decimal places.
Example: When the max. output
frequency value is 200.0, set 12000
Sets the brightness on the optional
LCD operator (JVOP-160).
0: light
1:
2:
3: normal
4:
5: dark
0: Below the active monitor param-
eter the next 2 sequential moni-
tors are diaplayed.
1: Below the active monitor the 2
monitors specified by o1-07 and
o1-08 are locked
Selects the monitor that is displayed
and locked in the second line of the
operator display.
Change
Access
during
Setting Factory
Range Setting Opera- Level
tion
6 to 53 6 Yes A
1 to 4 1 Yes A
0 to
0 No A
39999
0 to 5 3 Yes A
0 or 1 0 No A
1 to 53 2 No A
User Constant Tables
MEMO-
BUS Page
Register
500H 6-102
501H 6-102
502H 6-102
504H –
517H –
518H –
39
5-