Check And Recording User Constants - YASKAWA Varispeed E7 Instruction Manual And Parameter Description

Operation using the Digital Operator
Use the Digital Operator to start operation in LOCAL mode in the same way as in no-load operation.
•
For the case that a fault occurs during operation, make sure that the STOP key on the Digital Operator is
•
easily accessible.
At first, set the frequency reference to a low speed, e.g. to one tenth of the normal operating speed.
•
Checking Operating Status
Having checked that the operating direction is correct and that the machine is operating smoothly at slow
•
speed, increase the frequency reference.
After changing the frequency reference or the rotation direction, check that there is no oscillation or abnor-
•
mal sound from the motor. Check the monitor display to ensure that U1-03 (Output Current) is not too
high.
Refer to Adjustment Suggestions on page
•
control system occur.

Check and Recording User Constants

Use verify mode (i.e., when the VERIFY indicator on the Digital Operator lights up) to check user constants
that have been changed for trial operation and record them in a user constant table.
Any user constants that have been changed by autotuning will also be displayed in verify mode.
If required, the copy function in constants o3-01 and o3-02 displayed in advanced programming mode can be
used to copy the changed settings from the inverter to a recording area in the Digital Operator. If changed set-
tings are saved in the Digital Operator, they can be easily copied back to the Inverter to speed up system
recovery if for any reason the inverter has to be replaced.
The following functions can also be used to manage user constants.
Recording user constants
•
Setting access levels for user constants
•
Setting a password
•
Recording User Constants (o2-03)
If o2-03 is set to 1 after completing trial operation, the settings of user constants will be saved in a separate
memory area in the inverter. When the Inverter settings have been changed for any reason, the user constants
can be initialized to the settings saved in the separate memory area by setting A1-03 (Initialize) to 1110.
User Constant Access Levels (A1-01)
A1-01 can be set to 0 (monitoring-only) to prevent user constants from being changed. A1-01 can also be set
to 1 (User-specified Constants) to display only constants required by the machine or application in a program-
ming mode. These constants can be determined by setting the A2-XX constants.
Password (A1-04 and A1-05)
When the access level is set to monitoring-only (A1-01 = 0), a password can be set so that user constants will
be displayed only when the correct password has been input.
-10
4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4-11 if hunting, vibration, or other problems originated by the