YASKAWA Varispeed E7 Instruction Manual And Parameter Description page 66

Key Name
JOG Key
FWD/REV Key
Shift/RESET Key
Increment Key
Decrement Key
DATA/ENTER Key
RUN Key
STOP Key
Note: Except in diagrams, Keys are referred to the Key names listed in the above table.
There are indicators on the upper left of the RUN and STOP keys on the Digital Operator. These indicators
will light and flash to indicate operating status.
The RUN key indicator will flash and the STOP key indicator will light during initial excitation or DC brake.
The relationship between the indicators on the RUN and STOP keys and the Inverter status is shown in
3.2.
Inverter output frequency
Frequency setting
: Light up : Blinking
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 3.1 Key Functions (Continued)
Enables jog operation when the Inverter is being operated from the
Digital Operator.
Selects the rotation direction of the motor when the Inverter is being
operated from the Digital Operator.
Sets the active digit when programming user constants.
Also acts as the Reset key when a fault has occurred.
Selects menu items, sets user constant numbers, and increments set
values.
Used to move to the next item or data.
Selects menu items, sets user constant numbers, and decrements set
values.
Used to move to the previous item or data.
Pressed to enter menu items, user constants, and set values.
Also used to switch from one screen to another.
Starts the Inverter operation when the Inverter is being controlled by
the Digital Operator.
Stops Inverter operation.
This key can be enabled or disabled when operating from the control
circuit terminal by setting user constant o2-02.
: Not light up
Fig 3.2 RUN and STOP Indicators
Digital Operator
Function
Fig
3
3-