Table of Contents
Advertisement
Cable Inlet Box Components
The Cable Inlet Box includes the following components.
Cable harness.
l
Cable seal housing, 2 gaskets, 4 screws.
l
Cable entry top cover assembly including the Roxtec CF 8 frame.
l
4 x 2-hole Roxtec modules.
l
These are dense foam blocks surrounding pre-cut half-sleeves that can be peeled away
to match the diameter of the cable to be sealed.
Roxtec grease, used to assemble and seal the modules.
l
Ball Stud Locks
Under extreme loading conditions using very aggressive moves or in the case of a collision, it
is possible for the ball studs to separate from the ball joint sockets. Optional ball stud locks can
be used to prevent this from occurring.
A ball stud lock kit (16 locks) is available as part number 09824-000.
Additional Information: Refer to Installing or Removing Ball Stud Locks on
page 61 for more information.
22793-000 Rev. A
Figure 1-13. Cable Inlet Box
iX4 650 H/HS and 800 H/HS Robot with EtherCAT
User's Manual (Cat. No. I656)
Compression Unit
(Compression Wedge, Screw)
CF Frame
Cable Entry
Top Cover
Chapter 1: Introduction
25
Advertisement
Table of Contents
