Set Dot1X Max-Req - 3Com 3CRWX120695A Command Reference Manual

set dot1x max-req

Syntax —
set dot1x key-tx {enable | disable}
— Enables transmission of encryption key information to
enable
clients.
— Disables transmission of encryption key information to
disable
clients.
Defaults — Key transmission is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to enable key transmission:
WX4400# set dot1x key-tx enable
success: dot1x key transmission enabled.
See Also
"display dot1x" on page 421
Sets the maximum number of times the WX retransmits an EAP request
to a supplicant (client) before ending the authentication session.
Syntax —
set dot1x max-req number-of-retransmissions
number-of-retransmissions
Defaults — The default number of EAP retransmissions is 2.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To support SSIDs that have both 802.1X and static WEP clients,
MSS sends a maximum of two ID requests, even if this parameter is set to
a higher value. Setting the parameter to a higher value does affect all
other types of EAP messages.
Examples — Type the following command to set the maximum number
of EAP request retransmissions to three attempts:
WX4400# set dot1x max-req 3
success: dot1x max request set to 3.
set dot1x max-req
— Specify a value between 0 and 10.
427