Set Port Type Ap - 3Com 3CRWX120695A Command Reference Manual

82 C 4: P
HAPTER ORT

set port type ap

C
OMMANDS
— Enables the Telnet server.
enable
— Disables the Telnet server.
disable
Defaults — SNMP linkup and linkdown traps are disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The set port trap command overrides the global setting of the
set snmp trap command.
The set port type command does not affect the global trap information
displayed by the display snmp configuration command. For example, if
you globally enable linkup and linkdown traps but then disable the traps
on a single port, the display snmp configuration command still
indicates that the traps are globally enabled.
Examples — The following command enables SNMP linkup and
linkdown traps on ports 3 and 4:
WX1200# set port trap 3-4 enable
See Also
"display snmp configuration" on page 127
"set ip snmp server" on page 142
"set snmp community" on page 149
"set snmp trap" on page 150
"set snmp trap receiver" on page 153
Configures an WX switch port for an MAP access point.
CAUTION: When you set the port type for MAP use, you must specify
the PoE state (enable or disable) of the port. Use the WX switch's PoE to
power 3Com MAP access points only. If you enable PoE on a port
connected to another device, physical damage to the device can result.
Before configuring a port as an MAP access point port, you must use the
set system countrycode command to set the IEEE 802.11