Set Igmp Qri - 3Com 3CRWX120695A Command Reference Manual

set igmp qri

Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The query interval is applicable only when the WX is querier for
the subnet. For the WX switch to become the querier, the pseudo-querier
feature must be enabled on the WX and the WX must have the lowest IP
address among all the WX switches eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
Examples — The following command changes the query interval on
VLAN orange to 100 seconds:
WX1200# set igmp qi 100 vlan orange
success: change accepted.
See Also
"set igmp lmqi" on page 356
"set igmp oqi" on page 359
"set igmp qri" on page 361
"set igmp querier" on page 362
"set igmp mrouter" on page 356
"set igmp rv" on page 364
Changes the IGMP query response interval timer on one VLAN or all
VLANs on a WX.
Syntax —
set igmp qri tenth-seconds [vlan vlan-id]
qri tenth-seconds
the WX waits for a receiver to respond to a group-specific query
message before removing the receiver from the receiver list for the
group. You can specify a value from 1 through 65,535.
— VLAN name or number. If you do not specify a
vlan vlan-id
VLAN, the timer change applies to all VLANs.
Defaults — The default query response interval is 100 tenths of a second
(10 seconds).
Access — Enabled.
— Amount of time (in tenths of a second) that
set igmp qri 361