Set Rfdetect Active-Scan - 3Com 3CRWX120695A Command Reference Manual

458 C 17: RF D
HAPTER
set rfdetect
active-scan
C
ETECTION OMMANDS
Examples — The following command displays the devices detected by
3Com radio 00:0b:0e:00:0a:6a:
WX1200# display rfdetect visible 00:0b:0e:00:0a:6a
Total number of entries: 4
Transmit MAC
-----------------
00:0b:0e:00:02:01
00:0b:0e:00:03:41
00:0b:0e:00:0b:01
00:0b:0e:ff:00:01
The following command displays the devices detected by 3Com radio 1
on the MAP connected to WX port 3:
WX1200# display rfdetect visible ap 3 radio 1
Total number of entries: 3
Transmit MAC
-----------------
00:06:25:51:e9:ff
00:0b:0e:00:03:80
00:0b:0e:00:a6:00
Table 88 describes the fields in this display.
Table 88 display rfdetect visible Output
Field
Transmit MAC
Chan
RSS
See Also
"display rfdetect data" on page 453
"display rfdetect mobility-domain" on page 455
Disables or reenables active RF detection scanning on a WX switch. When
active scanning is enabled, the MAP radios managed by the switch look
Chan
-------- -------
56
36
52
36
Chan
-------- -------
10
1
1
Description
BSSID of the device.
BSSIDs that begin with 00:0b:0e belong to other 3Com
radios.
Number of the channel on which the MAP radio detected
the BSSID.
Received signal strength indication (RSSI) — the strength of
the RF signal detected by the MAP radio, in decibels referred
to 1 milliwatt (dBm).
RSS
-74
-44
-79
-84
RSS
-77
-79
-71