Set {Ap | Dap} Radio Auto-Tune Max-Power - 3Com 3CRWX120695A Command Reference Manual

266 C 9: M
HAPTER ANAGED
set {ap | dap} radio
auto-tune
max-power
A P C
CCESS OINT OMMANDS
See Also
"display {ap | dap} config" on page 234
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax —
set {ap port-list | dap dap-num } radio {1 | 2}
auto-tune max-power power-level
— List of ports connected to the MAP access points on
ap port-list
which to set the channel.
— Number of a Distributed MAP on which to set the
dap dap-num
channel.
— Radio 1 of the MAP.
radio 1
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
— Maximum power setting RF Auto-Tuning can assign
power-level
to the radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the maximum
value allowed for the country of operation.
The power-level can be a value from 1 to 20.
Defaults — The default maximum power setting that RF Auto-Tuning
can set on a radio is the highest setting allowed for the country of
operation or highest setting supported on the hardware, whichever is
lower.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the maximum power that
RF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to
12 dBm.
WX1200# set ap 6 radio 1 auto-tune max-power 12
success: change accepted.
See Also
"set {ap | dap} radio auto-tune max- retransmissions" on page 267
"set radio-profile auto-tune power-backoff- timer" on page 279