Set {Ap | Dap} Radio Mode - 3Com 3CRWX120695A Command Reference Manual

set {ap | dap} radio
mode
After all clients are at or above the minimum data transmit rate, the radio
reduces power by 1 dBm. As long as the radio continues to transmit at
the minimum data rate or higher for all clients, the radio continues
reducing power in 1 dBm increments until it returns to its normal power
level.
A radio also can increase power, in 1 dBm increments, if more than the
allowed percentage of packets received by the radio from a client are
retransmissions. After a radio increases power, all clients must be at the
minimum data rate or higher and the maximum retransmissions must be
within the allowed percentile, before the radio begins reducing power
again.
Examples — The following command increases the minimum data rate
on radio 1, which is an 802.11b/g radio on the MAP access port on port
6, to 11 Mbps.
WX1200# set ap 6 radio 1 min-client-rate 11
success: change accepted.
See Also
"set radio-profile auto-tune power-backoff- timer" on page 279
"set radio-profile auto-tune power-config" on page 280
Enables or disables a radio on an MAP access point.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
mode {enable | disable}
— List of ports connected to the MAP access point(s) on
ap port-list
which to turn a radio on or off.
— Number of a Distributed MAP on which to turn a
dap dap-num
radio on or off.
— Radio 1 of the MAP.
radio 1
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
— Enables a radio.
mode enable
— Disables a radio.
mode disable
Defaults — MAP access point radios are disabled by default.

set {ap | dap} radio mode

271