Set Service-Profile Auth-Psk - 3Com 3CRWX120695A Command Reference Manual

298 C 9: M
HAPTER ANAGED
set service-profile
auth-psk
A P C
CCESS OINT OMMANDS
See Also
"display service-profile" on page 257
"set web-aaa" on page 220
"set service-profile web-aaa-form" on page 308
Enables preshared key (PSK) authentication of Wi-Fi Protected Access
(WPA) clients by MAP radios in a radio profile, when the WPA information
element (IE) is enabled in the service profile.
Syntax —
set service-profile name auth-psk {enable | disable}
— Service profile name.
name
— Enables PSK authentication of WPA clients.
enable
— Disables PSK authentication of WPA clients.
disable
Defaults — When the WPA IE is enabled, PSK authentication of WPA
clients is enabled by default. If the WPA IE is disabled, the auth-psk
setting has no effect.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command affects authentication of WPA clients only.
To use PSK authentication, you also must configure a passphrase or key.
In addition, you must enable the WPA IE.
Examples — The following command enables PSK authentication for
service profile wpa_clients:
WX4400# set service-profile wpa_clients auth-psk enable
success: change accepted.
See Also
"display service-profile" on page 257
"set service-profile auth-dot1x" on page 295
"set service-profile psk-raw" on page 304
"set service-profile wpa-ie" on page 312