3Com 3CRWX120695A Command Reference Manual page 252

252 C 9: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
Usage — To show information only for Distributed MAPs that have active
connections, use the display dap connection command.
Examples — The following command displays configuration information
for all Distributed MAPs configured on WX switches in the Mobility
Domain:
WX4400# display dap global
Total number of entries: 8
DAP Serial Id
--- -----------
1 M9DE48B012F00 10.3.8.111
- M9DE48B012F00 10.4.3.2
2 M9DE48B123400 10.3.8.111
- M9DE48B123400 10.4.3.2
17 M9DE48B123600 10.3.8.111
- M9DE48B123600 10.4.3.2
18 M9DE48B123700 10.3.8.111
- M9DE48B123700 10.4.3.2
Table 53 describes the fields in this display.
Table 53 Output for display dap global
Field
DAP
Serial Id
WX IP Address
Bias
See Also
"display {ap | dap} config" on page 234
"display dap connection" on page 250
"display dap unconfigured" on page 253
WX IP Address
--------------- ----
Description
Connection ID you assigned to the Distributed MAP.
Note: DAP numbers are listed only for Distributed MAPs
configured on this WX switch. If the field contains a
hyphen ( - ), the Distributed MAP configuration displayed in
the row of output is on another WX switch.
Serial ID of the Distributed MAP.
System IP address of the WX switch on which the Distributed
MAP is configured. A separate row of output is displayed for
each WX switch on which the Distributed MAP is configured.
Bias of the WX switch for the Distributed MAP:
High
Low
Bias
HIGH
LOW
LOW
HIGH
HIGH
LOW
LOW
HIGH